1.7

l
Reload All: Restores all Section properties to the default values set in the
template for each Section.
l
Apply finishing from: Displays a list of available Sections. Clicking on a
Section name loads that Section's properties into the current Section to edit.
l
Apply current finishing to all sections: Applies the current properties to
all Sections.
l
Binding group:
l
Style: What type of Binding to request on the printer. This includes Stapled, Glued,
Stitched, Ring, and various other options..
l
Side: Sets the side of the paper that the Binding is to occur.
l
Location: Sets where the binding is to occur, if applicable.
The selections available here are dependent upon the selection made in the
Binding Style. Only Stapled and Stitched bindings have a Location option
available to them.
l
Angle: Set Stapling or Stitching binding either horizontally, vertically, or at an angle
(as supported by printer).
l
Item count: Select the amount of Staples or Stitches to use. The choice is between
the default amount or selecting a specific number using the Count option.
Tip
The options actually available to you at print time will be printer dependent, so
you will need to know the capabilities of your printer, or leave the value set to
Default.
l
Area: The area where the binding can be applied.
l
Hole making group:
Hole making options are available only to Ring, Comb (wire and plastic) and Coil Binding
Styles. The selections will need to be made at run-time based upon the types of binding
options available that the printer supports.
l
Number of holes: The number of holes to punch for the selected Binding option.
l
StyleThe style of hole punches for the selected Binding option.
l
Pattern Catalog ID: The Catalog IDof the selected Binding option.
Page 711