1.4

l
Left, top, right, bottom: Enter a measure for the margins on each side of the OMR
Marks.
l
Custom OMRmark sizing: If supported by the chosen Mark Configuration you can select
a Custom OMR size.
You can select from any of the following, or leave the entries blank to use default values:
l
Line length: Enter a value between 10.16mm and 20mm.
l
Line thickness: Enter a value between 0.254mm and 0.63mm.
l
Gap distance: Enter a millimeter value 2.91mm and 4.2mm.
Mark Position Options
This page displays a Preview of the output and the possible locations to place the inserter
marks. The initial settings are determined by the selections made within the "Inserter Options"
on the previous page page.
You can move back and forward between these two pages to perfect the settings, or you could
move the inserter mark box to the desired location on the preview.
Preview box:
l
The pink area displays the sections of the page where inserter marks can be positioned.
l
The small checkered box displays the current location of the inserter marks. This box is
selectable and can be dragged to the desired location within the printable (pink) areas.
If the box is placed outside the printable areas the page will display an error and prevent
attempts at leaving the page.
Below the Preview box are buttons which allow control of the Preview box. The selections that
can be made are:
l
First Page: Click to jump to the first page.
l
Previous Page: Click to move to the previous page.
l
Next Page: Click to move to the next page.
l
Last Page: Click to jump to the last page.
l
Show Page: Use the up and down arrows or type a page number to display a specific
page within the document.
l
Zoom in/out: Click to zoom in or out by 25%
Page 596