1.4
Table Of Contents
- Table of Contents
- Welcome to PlanetPress Connect 1.4.2
- Setup And Configuration
- DataMapper Module
- The Designer
- Mark Position Options
- Additional Text Settings
- Additional Image Settings
- Barcode Options
- Codabar Settings
- Code 128 Settings
- Code 39 Settings
- Additional Datamatrix Settings
- Additional EAN 128 Settings
- Additional EAN 13 Settings
- Additional EAN 8 Settings
- Additional Interleave 2 of 5 Settings
- Additional PDF417 Settings
- Additional QR Code Settings
- Additional UPC A Settings
- Additional UPC E Settings
- Additional OMR Mark Settings
- Keystore
- PDF Signature
- Copyright Information
- Legal Notices and Acknowledgements
l
Use Grouping: Check to activate the Grouping and Splitting Options page of the
wizard.
l
Apply filtering and sorting to record selection: Check to activate the Data
Filtering Options page of the wizard.
l
Include Metadata (PDF and AFP only): Check to activate the Metadata Options
page of the wizard.
l
Override Finishing Options: Check to activate the Finishing Options.
l
Next: Click to go to the next page of the Job Creation Wizard, Data Filtering Options
l
Finish: At any point during the wizard, click to save the current configurations, whatever
page you are on.
l
Cancel: At any point during the wizard, click to exit the wizard without saving changes.
Finishing Options
Use this dialog to force specific finishing options, instead of using finishing options that were
set in the Template's Media and Section options.
This is only applied when producing print output. It does not modify the original finishing
options in either the Section or the Template.
l
Ignore section level finishing: Check to override finishing options at the document level
only.
l
Section to edit: Use the drop-down to select which Section to apply the options below.
The Document level is also listed to edit document-level finishing.
l
Settings: Click the settings button to bring up control options:
l
Reload: Restores the current section's properties to the default values set
in the template for this section
l
Reload All: Restores all section properties to the default values set in the
template for each section.
l
Apply finishing from: Displays a list of available sections. Clicking on a
section name loads that section's properties into the current section to edit.
l
Apply current finishing to all sections: Applies the current properties to
all sections.
l
Binding group:
l
Style: What type of Binding to request on the printer. This includes Stapled, Glued,
Stitched, Ring, and various other options..
l
Side: Sets the side of the paper that the Binding is to occur.
l
Location: Sets where the binding is to occur, if applicable.
The selections available here are dependent upon the selection made in the
Page 582