1.4

l
Condition: Enter the condition which determines whether or not the OMR Mark will
be added to the document at print time.
For details on how to create a conditional, see the Conditionals page.
l
OMRMarks Tab:
l
#: OMR Mark number (display only).
l
Type: Type of OMR Mark (display only).
l
Value: OMR Mark Value. These can be selected and altered for Sequence, Match
and Parity marks, as described below.
l
Add: Add an OMRMark entry to the table.
Choices are between:
l
On: This represents a mark that is always printed
l
Off: This represents a mark that is never printed.
i.e. it pads the marks out with an empty position
l
Group Start: This represents a mark that is printed on the first page of a group
l
Group End: This represents a mark that is printed on the last page of a group
Note
In a single page group both Group Start and End marks will print if
defined since the page is both the start and end of the group.
l
Sequence: This represents a mark that is printed when the specified bit is set
in the sequence number of the page.
For example, if the bit for the mark is set to 2 and the sequence number for the
page is 5 then it will not print since the value 5 consists of the bits 1 and 4.
Use the drop down box to select the entry.
l
Match: This represents a mark that is printed when the specified bit is set in
the match number of the group.
For example, if the bit for the mark is set to 2 and the match number for the
group is 3 then it will print since 3 consists of the bits 1 and 2.
Use the drop down box to select the entry.
Note
The match number is the same for all pages in a group
Page 575