1.4

Additional OMR Mark Settings
The Add OMR dialog displays the properties of an OMRMark that was added in the
"Additional Text" on page 543 page.
These OMRmarks differ from HCF generated inserter marks. Those marks are specific to the
inserter machine they were created for, whereas these additional OMR marks are completely
independent and customizable. These custom OMR marks can be used to cater for inserter
machines not currently support by a HCF, or they can be used for any non-inserter related post
processing driven by OMR marks
l
Position group:
l
Orientation: Use the drop-down to select the orientation of the OMRMark added to
the page.
l
Page Side: Select whether the OMRMark will print on the front or back of page.
l
Left: Enter the distance between the left margin of the page and the OMRMark, in
either metric (cm/mm) inch (in) or point (pt) values.
l
Bottom: Enter the distance between the bottom margin of the page and the OMR
Mark, in either metric (cm/mm), inch (in) or point (pt) values.
l
Options Tab:
l
Collation Level: Choices are:
l
Document: Treats each document as a group and the group and match marks
will be set based upon the start and end of a document.
l
Document Set: Treats each document set as a group and the group and
match marks will be set based upon the start and end of a document set.
l
Draw Hot Spots: This adds a red rectangle around the location of each individual
mark in the output, allowing easier checking of the OMRmark logic.
l
Line Options group
l
Line Thickness: Sets the thickness of each OMR mark line.
l
Line Length: Sets the lenght of each OMR mark line.
l
Line Spacing: Determines how the spacing between each OMR mark line will
be determined. The associated control beneath the combination box will be
enabled, based upon this selection.
Page 573