1.4

button to move to the "Mark Position Options" on page 596 page, which has a preview of
the page. You can move back and forward between these two pages until you are entirely
satisfied with the selections made.
l
Mark Configuration: Use the drop-down to select the type of markings to add. This
selection basically equates to the amount of area the markings will take up on the
printed page.
l
Fold Type: Use the drop-down to select the type of fold to apply to the paper. This
will impact upon where on the page the markings will be placed.
l
Collation level: Select whether the markings will be made at Document level, or
Document Set level.
l
Print marks on back: Check to place the Inserter Marks on the rear of the page.
l
Selective Inserts:If selective inserts are supported by the chosen Mark
Configuration you can select what markings to include and whether those markings
are to included based upon some conditional setting.
For example, you could add a marking to the third page of a document by making
the selection Conditional and then setting the Condition entry to "page.nr = 3".
l
Clear Background Area: Check to add a white background to the OMR, preventing
background colors or elements interfering with the OMR Markings when they are read by
the Inserter.
l
Margins:
l
Same for all sides: Check so that the Left margin selection is used to set all sides
identically.
l
Left, top, right, bottom: Enter a measure for the margins on each side of the OMR
Marks.
l
Custom OMRmark sizing: If supported by the chosen Mark Configuration you can select
a Custom OMR size.
You can select from any of the following, or leave the entries blank to use default values:
l
Line length: Enter a value between 10.16mm and 20mm.
l
Line thickness: Enter a value between 0.254mm and 0.63mm.
l
Gap distance: Enter a millimeter value 2.91mm and 4.2mm.
Page 537