1.4

l
Page Order: Select in which direction to go when adding sections to the output:
l Left to right, then top to bottom
l
Right to left, then top to bottom
l Top to bottom, then left to right
l Top to bottom, then right to left
l
Stack Depth: Enter a stack depth or use the arrows to increment or decrement.
l
Reverse Pages: Select this option to reverse the order of pages.
This would print the final record on the first page and the first record on the last
page.
l
Force simplex: Select this option to make the output Simplex, rather than the
imposition default of Duplex.
l
Bleed Margins group:
l
Top, Bottom, Left, Right: Enter the bleed margins for each side of the page.
l
CropMarks group:
l
Type: Use the drop-down to select the type of crop marks to add to the page.
l
Offset: How much separation (if any) to leave between the vertical and horizontal
corner markings.
l
Width: Select the width of the crop mark lines.
l
Length: Select the Length of the crop mark lines.
Inserter Options
The Inserter Options page allows the selection of a High Capacity Feeder (HCF) model. These
machines are also commonly referred to as Inserters or Folder-Inserters.
The options available on this page are dependent upon the model selected.
The options selected on this page influence the position of the markings set on the next page:
"Mark Position Options" on page 596.
l
Model: Use the drop-down to select from any previously loaded Inserter model, or use the
Browse button to select a HCF file to load a new Inserter model.
An image representing the chosen folder-inserter is displayed under the list, along with
the HCFfile details.
l
Options Group:
The options available here are all Inserter dependent, and thus will change based upon
the Inserter model selection.
To see how the selected Inserter markings would look on the printed page, click the Next
Page 536