VH-R2 Tilt Head You’re on steady ground™ 1
Introduction Thank You for choosing Oben! This sturdy Oben VH-R2 Tilt Head provides smooth, accurate, and quick operation for a 180° vertical tilt. The quick-release latch features a locking pin to prevent accidental camera release. Included with the Tilt Head is a snap-in quickrelease plate for rapid mounting and dismounting of the camera, and a reducer bushing to ensure a proper fit to your monopod or tripod.
TABLE OF CONTENTS Key Features 4 Mount Tilt Head To Monopod 5 Converting Mounting Thread 5 Tilt Locking Knob 5 Dual-Locking Quick Release 6 Mount Quick-Release Plate 6 Mount Camera 6 Warnings 7 3
KEY FEATURES C A B D A Quick-Release Plate B Dual-Locking Quick Release C 1/4”-20 UNC Mounting Screw D Tilt Locking Knob 4
OPERATION 1. Mount Tilt Head To Monopod To mount the head on a monopod, first tighten the tilt locking knob on the head. Then, being careful to properly align the monopod stud with the head’s mounting hole to avoid damaging them, rotate the head clockwise onto the monopod and hand-tighten. 2. Converting Mounting Thread For monopods with a 1/4″ threaded mounting stud: insert the supplied reducer bushing into the threaded mounting hole of the head to enable a proper fit. 3.
OPERATION 4. Dual-Locking Quick Release The VH-R2 Tilt Head is designed with a dual-locking quick-release latch to keep the camera securely in place on the head. To unlock the quick-release, press the small latch while pulling outward on the main latch at the same time. 5. Mount Quick-Release Plate Mount the quick-release plate to the threaded hole on the base of your camera. The plate utilizes a 1/4″-20 screw that will fit most cameras.
OPERATION ! Warnings: • Do not exceed the head’s maximum load capacity of 11 lb (5 kg). • Ensure that all appropriate locks are engaged when necessary. • The VH-R2 head should only be used in temperatures ranging between -4° and 158° F (-20° and 70°C). • Do not operate in saltwater. Dry head if it becomes wet. • Remove the camera from the head during setup or transport. • Avoid long-term exposure to sunlight. • Keep out of reach of children. Visit our website at ObenSupports.com for more Oben products.
www.obensupports.
