Oben AC-2300L, CC-2300L & 2400L Series User Manual

9
The tripod includes a mounting
screw with a 1/4” screw on one
end and a 3/8” screw on the other,
allowing you to mount either size
tripod head. To switch between
the two sizes, remove the plate
from the tripod by turning it
counter-clockwise.
Remove the screw, and insert the
opposite end back into the plate.
Mount the plate back onto the
tripod by turning it clockwise.
To mount a head, align the
bottom of the tripod mount with
the tripod’s mounting screw,
then twist clockwise until fully
secured. Do not over-tighten, as
this may cause damage to the
tripod or head.
The top plate on Oben tripods is
equipped with three set screws
which clamp against the base of
the tripod head to ensure eective
and secure locking of the head to
the tripod.
Note: To prevent possible damage to your camera, remove the
camera from the tripod head before mounting the center column
horizontally.
Note: To prevent possible damage to your camera when using the
center column mounted horizontally, make sure to counterbalance
the column or slide the column to shorten the length extending from
the tripod so that the weight of the camera does not unbalance the
tripod, causing it to fall over.
6. Mounting the Head
callouts
leg angle adj
center clm adj
attaching head
low angle adj
180°
oPErAtIon