AC-2300L/CC-2300L/2400L Series Lateral Tripod You’re on steady ground™ 1
Introduction Thank You for choosing Oben! Congratulations on your purchase of this sturdy, multi-featured Oben AC-2300L/CC-2300L/ CC-2400L Series lateral tripod. It will deliver lightweight, rock-solid support for your camera for years to come. In addition to providing normal vertical tripod support for your camera, the center column of this tripod can be placed in a horizontal position and rotated from 90° up to 90° down from the horizontal. The camera can be placed at any point in this 180° range.
TABLE OF CONTENTS Key Features 5 Retractable Spiked Feet 6 Leg Length Adjustment 6 Leg Angle Adjustment 6 Center Column Adjustment 7 Low-Angle Setup 8 Mounting the Head 9 Warnings 10 Notes 11 3
adj KEY FEATURES callouts A F E C B D G L H J I K 4
KEY FEATURES A Center column locking knob B Center column release push-button C Center column angle locking knob D Center column rotating locking knob E Square shaped center column F Head locking screws G Leg angle adjustment lock H Flip-style leg lock levers I All-terrain feet J Dual 3/8”-1/4”-20 head mounting screw K Strap mount L Rubberized non-slip leg warmer (for aluminum models only) 5
OPERATION 1. Retractable Spiked Feet A spike is built into each of the tripod’s rubber feet. The rubber non-skid feet are for use indoors or on flat surfaces, while the spikes are for soft ground, grass, sand, and uneven terrain. To extend the spike, rotate the rubber pad at the bottom of the foot clockwise until the spike is fully exposed. Turn the foot counterclockwise to retract the spike into the rubber foot. 2.
OPERATION To change a leg’s angle, pull the adjustment lock outward and set the angle of the leg. Push the lock in to lock the leg at that angle. attaching head 4. Center Column Adjustment center clm adj The sliding center column can be used to adjust the height of the camera. Fully extending the center column after the legs have been fully extended will place the camera at the highest position possible with this tripod.
OPERATION Low-Angle nter5.clm adj Setup Remove your camera from the tripod. Then twist the center column locking knob counterclockwise to unlock the center column. Pull the center column up while pressing on the push button located on the bottom of the center column. When the bottom of the center column clears the tripod’s top plate, turn the center column angle locking knob 180° centertoclm adjit counterclockwise loosen and tilt the center column to the desired angle.
OPERATION Note: To prevent possible damage to your camera, remove the camera from the tripod head before mounting the center column horizontally. Note: To prevent possible damage to your camera when using the center column mounted horizontally, make sure to counterbalance the column or slide the column to shorten the length extending from the tripod so that the weight of the camera does not unbalance the tripod, causing it to fall over. g angle adj e adj 6.
WARNINGS ! • Do not exceed the tripod’s maximum load capacity (see tag on tripod). • Ensure that all appropriate locks are engaged when necessary. • Tripod should only be used in temperatures between -22° and 140° Fahrenheit. • Do not operate in salt water. Dry tripod off if it becomes wet. • Remove the camera from the tripod during transport. • Keep out of reach of children.
NOTES ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ________
www.obensupports.
