Installation Guide

INSTRUCTION GUIDE
Oatey.com
©2023 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specification limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
Connect drain trap assembly to adjustable waste arm with elbow.
Connect (B) to (C) (elbow) using the nut assembled on the elbow.
Leave this assembly loose for further connection. Swivel (D) (waste
arm) into position to assemble to (C) (elbow). Connect (D) to (C) using
a nut and washer provided. Note: (D) (waste arm) may be trimmed to
length. Remove all burrs from cut process.
8
7
Connect adjustable waste arm to drain tee. Connect (D) (waste arm) to (E) (drain tee) using a nut and washer
provided. Leave the assembly loose for further connections.
Connect drain trap to wall drain pipe. Measure the length needed to connect to the wall drain pipe. Trim (A) if
needed. Connect (A) (drain trap arm) assembly with nut and washer. Hand tighten. Note: be sure to remove all
burrs from cut process.
6
Assemble drain trap. Assemble (A) (waste arm) to (B) (drain trap) using a nut only. Leave assembly loose.
5
DISPOSAL INSTALLATION KIT
Connect dishwasher discharge line. Connect (H) (disposal connector) to (J) (barbed fitting) using the clamp provided. Be
sure to use the tight fitting end of (H). Tighten clamp. Connect the existing dishwasher discharge hose to the opposite
end of (J) using clamp from existing discharge hose. Tighten clamp. Connect the opposite end of (H) to the existing
disposal unit with clamp provided. Tighten clamp.
4
3
Connection to disposal and drain tee. Remove existing mounting flange and screw from disposal unit. Do not discard.
Connect (F) (tailpiece) flange end and (G) (gasket) to disposal unit using the existing flange and screw. Connect other
end of (F) to (E) using a nut and washer. Hand tighten. Note: (F) (tailpiece) may be trimmed to length. Remove all burrs
from cut process.
Connect tailpiece to drain tee. Use a nut and washer to secure (K) to
(E) (drain tee). Hand tighten.
2
Tighten all connections. CHECK FOR LEAKS.
9
Connection to sink. Remove existing nut and washer from sink
strainer. Secure (K) (tailpiece) flange end to sink strainer with nut and
washer. Hand tighten.
1