Installation Guide

INSTRUCTION GUIDE
Oatey.com
©2023 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specification limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
GARBAGE DISPOSAL CONNECTOR
3
2
1
4
Measure and cut the dishwasher discharge hose to the
desired length.
Slide cut discharge hose over the small end of the
connector. Secure with hose clamps, being sure not
to overtighten.
Slide the larger end of the connector over the inlet of the
garbage disposal or branch tee. Secure with hose clamps.
Check for leaks. If leaks occur, tighten another ¼ turn.