Installation Guide
NO-CAULK PREFORMED DRAINS
INSTRUCTION GUIDE
2
3
4
5
7
8
6
9
1
Apply ½ in. bead of Oatey Plumbers Putty around the
underside of the no-caulk barrel ange.
Oatey No-caulk Shower Drains are designed with a drain body that seals to the shower base with washers.
For use with preformed shower bases, these drains come with a universal snap-in strainer in a variety of
nishes that complement your bathroom’s existing décor. Oatey products have earned the trust of plumbing
professionals for over 100 years.
Place the no-caulk barrel through the top side of the shower
base hole.
Compress down as far as you can without twisting.
Place the rubber sealing washer and friction washer over the
barrel to the underside of the shower base.
Tighten the locking ring using adjustable pliers.
Once fully tightened, remove any excess plumbers’ putty from the top of the drain.
Place the rubber pipe gasket bevel side up over the drainpipe coming up through the no-caulk barrel.
Push down on the rubber pipe gasket until it sets at the bottom of the no-caulk barrel.
Snap in drain cover.
Install shower base into nal location.
Thread the gasket set screw into place over the drainpipe with the provided wrench and tighten
with a screwdriver.
©2023 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specication limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
Oatey.com