Dimensions Guide

ManualsBrandsOatey ManualsAir Admittance Valves160 DFU ABS Sure-Vent Air Admittance Valve

Job Name Item #

Location

Engineer Contractor

PO # Tag

Representative

AIR ADMITTANCE VALVES

TECHNICAL SPECIFICATION

SPECIFICATIONS

The purpose of an Air Admittance Valve is to provide a method of allowing

air to enter the plumbing drainage system without the use of a vent extended

to open air and to prevent sewer gases from escaping into a building. An Air

Admittance Valve is a one way valve designed to allow air to enter the plumbing

drainage system when negative pressures develop in the piping system. The

device shall close by gravity and seal the vent terminal at zero differential

pressure (no ﬂow conditions) and under positive internal pressures.

APPROVALS & LISTINGS

ASSE 1050 & 1051

ICC ESR-1664

NSF Standard 14

IAPMO – Classiﬁed Mark

ASTM D 2665/D 2661

International Plumbing Code (IPC) 2003

International Residential Code (IRC) 2003

INSTALLATION

Read installation instructions prior to use of this product. Always consult

local plumbing codes prior to installing an AAV. Individual, branch and circuit

vents are permitted to terminate with a connection to a Sure-Vent

AAV. The

Sure-Vent

AAV will only vent ﬁxtures that are on the same ﬂoor and connect

to a horizontal branch drain. The horizontal branch drain shall connect to

the drainage stack a maximum of four branch intervals from the top of the

stack. The Sure-Vent

AAV should be located within the maximum developed

length permitted for the vent. The Sure-Vent

AAV must be located a

minimum of 4 inches above the horizontal branch drain and 6 inches above

any insulation material and within 15 degrees of vertical. Every structure in

which plumbing is installed shall have at least one primary stack vent. The

stack vent should run as directly as possible from the building drain through

to the open air.

Apply approved pipe joint compound or thread seal tape to the male threads

of the valve. Remove protective sleeve after installation.

Oatey Co. | 20600 Emerald Parkway, Cleveland, OH 44135 | P: 1.800.321.9532 | oatey.com

FEATURES & MATERIALS

Access BIM/Revit content through www.oatey.com

Tension

Membrane

Silicone

Sweet Spot

™

Sweet Spot

™

technology opens at -0.01 psi

and seals at 0 psi and above

Screening Screening on air inlets to guard the seal

Grip

Protective sleeve provides grip for installation

and keeps valve free from debris

Tested

100% functionally tested at ¼" H

O and 30" H

ensuring trouble free performance

Warranty Limited Warranty

6/19

Summary of content (4 pages)

PAGE 1
AIR ADMITTANCE VALVES TECHNICAL SPECIFICATION Job Name Item # Location Engineer Contractor PO # Tag Representative SPECIFICATIONS The purpose of an Air Admittance Valve is to provide a method of allowing air to enter the plumbing drainage system without the use of a vent extended to open air and to prevent sewer gases from escaping into a building.
PAGE 2
AIR ADMITTANCE VALVES TECHNICAL SPECIFICATION DFU Rating Connection Membrane Adapter A 20 Branch, 8 Stack 1.5" PVC NPT Threads Silicone 1.5" PVC B 160 Branch, 24 Stack 2" PVC NPT Threads Silicone 1.5" x 2" PVC or ABS C 160 Branch, 72 Stack 2" PVC NPT Threads Silicone 2" x 3" PVC or ABS D 160 Branch, 500 Stack 3" PVC NPT Threads Silicone 3" x 4" PVC or ABS A. A. 2.62 2.54 3.59 1.65 2 in Hub All dimensions in inches B. C. All dimensions in inches D.
PAGE 3
AIR ADMITTANCE VALVES TECHNICAL SPECIFICATION PRODUCT SELECTOR 20 BRANCH, 8 STACK DFU SURE-VENT AIR ADMITTANCE VALVE WITH SCHEDULE 40 ADAPTER P Product Number Description Pack 39228 20 BRANCH, 8 STACK DFU SURE-VENT, 1.5 IN, W/PVC SCHED 40 ADAPTER 6 39229 20 BRANCH, 8 STACK DFU SURE-VENT, 1.5 IN, W/ABS SCHED 40 ADAPTER 6 39005 20 BRANCH, 8 STACK DFU SURE-VENT, 1.5 IN PVC SCHED 40 ADAPTER 50 39227 20 BRANCH, 8 STACK DFU SURE-VENT, 1.
PAGE 4
AIR ADMITTANCE VALVES TECHNICAL SPECIFICATION PRODUCT SELECTOR 160 BRANCH, 24 STACK DFU SURE-VENT AIR ADMITTANCE VALVE WITH SCHEDULE 40 ADAPTER P Product Number Description Pack 39016 160 BRANCH, 24 STACK DFU SURE-VENT, 1.5 X 2 IN PVC SCHED 40 ADAPTER 6 39018 160 BRANCH, 24 STACK DFU SURE-VENT, 1.5 X 2 IN ABS SCHED 40 ADAPTER 6 39017 160 BRANCH, 24 STACK DFU SURE-VENT, 1.5 X 2 IN PVC SCHED 40 ADAPTER 50 39019 160 BRANCH, 24 STACK DFU SURE-VENT, 1.