Submittal Sheet

Job Name Item #
Location
Engineer Contractor
PO # Tag
Representative
MODA
™
WASHING MACHINE
OUTLET BOX (SINGLE)
TECHNICAL SPECIFICATION
SPECIFICATIONS
Oatey MODA
™
washing machine outlet boxes shall be used in residential
or commercial applications requiring supply valves and a waste drain
recessed in the wall. The MODA
™
washing machine assembly contains
two supply valves and a drain connection, with inter-locking wing flanges
on each side. Box shall be manufactured of PVC, allowing solvent welded
joints to be prepared in accordance with ASTM D2855 for PVC drainage
systems (without the use of specialty cements). The wing flanges shall
allow installation on a single stud, or between two studs in combination
with the included side brackets. No additional components shall be
required for a between stud installation. Valves shall be a two-piece
design, permitting field replacement, and shall be secured with a stainless
steel retention clip. Valves are available with or without water hammer
arrestors and shall be installed in an inverted configuration. The assembly
shall include a knockout cap for DWV testing.
APPROVALS & LISTINGS
Valves
ASME A112.18.1 / CSA
B125.1 / ANSI 61 + 372
Water Hammer Arrestors ASSE 1010
Boxes IAPMO-Listed, PS-54
FEATURES & MATERIALS
Outlet Box & Brackets PVC
Valve Body Forged Brass C37700
Valve Retention Clip Stainless Steel
Valve O-Rings NSF/FDA Approved EPDM (2)
PERFORMANCE SPECIFICATIONS
Temperature Rating (Valve) 250° F / 121° C
Max Testing Pressure (Valve) 100 psi (Air) / 250 psi (Water)
DIMENSIONS
[A]: Box Width 8.00" [E]: Bracket Length 8.00"
[B]: Box Depth 3.38" [F]: Faceplate Width 6.00"
[C]: Box Height 4.85" [G]: Faceplate Height 6.45"
[D]: Bracket Width 4.00" [H]: Faceplate Depth 1.25"
Oatey Co. | 20600 Emerald Parkway, Cleveland, OH 44135 | P: 1.800.321.9532 | oatey.com
Access BIM/Revit content through www.oatey.com
5/19
Accessory Components Included:
Side Brackets (2)
Sticker Cover
(For Debris Protection)
Faceplate