Installation Guide
BELL HANGER
INSTRUCTION GUIDE
2
3
4
1
Choose desired location for support i.e., stud, joist,
or finished wall surface. Check with local codes to
determine spacing between clamps.
Loosen the two short Philips head screws to allow the
top half of the clamp to swivel freely .
Anchor the Bell Hanger into the final location using the
long course thread screw (provided). If securing Bell
Hanger to concrete, discard the provided course screw
and use an approved concrete anchoring method.
Insert pipe into clamp and tighten short Phillip head screws to secure pipe into place.
©2021 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specication limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
Oatey.com