Technical Specifications

Oatey Co. | 20600 Emerald Parkway, Cleveland, OH 44135 | 800.203.1155 | Oatey.com

Oatey Co. is part of the Oatey family of companies

Job Name Item #

Location

Engineer Contractor

PO # Tag

Representative

PVC REGULAR

CLEAR CEMENT

TECHNICAL SPECIFICATION

8/19

VOC

Maximum VOC per SCAQMD 1168/316A or

BAAQMD Method 40: 510 g/L

CHEMICAL PROPERTIES

Appearance Clear Liquid

Viscosity Min. 90° cps @73° F ± 2° F

Density 7.47 ± 0.2 lbs/gallon

Shelf Life 3 years from Mfg. date

SET TIME / CURE TIME

30° F to 50° F 5 – 6 minutes

50° F to 70° F 3 – 4 minutes

70° F to 90° F 1 – 2 minutes

PRODUCT NUMBER SIZE DESCRIPTION CTN. QTY

31012 4 oz. PVC Regular Clear Cement 24

31013 8 oz. PVC Regular Clear Cement 24

31014 16 oz. PVC Regular Clear Cement 24

31015 32 oz. PVC Regular Clear Cement 12

31016 Gallon PVC Regular Clear Cement 6

SPECIFICATIONS

• Regular-Bodied Clear cement for use on all schedules and classes of

PVC pipe and ﬁttings up to 4" for Sch. 40 and up to 2" for Sch. 80.

• Lo-V.O.C. Solvent Cement meets California South Coast Air Quality

Management District (SCAQMD) 1168/316A or BAAQMD Method 40

and various environmental requirements.

APPLICATION / USES

• Recommended for potable water, pressure pipe, conduit and DWV.

PROPERTIES

Compliant with LEED Requirements. Solvent cements may be speciﬁed

under the LEED v4 EQ for Low-Emitting Materials to obtain points

ASTM Standard D2564, NSF Standard 61 for PW,

DWV and Sewer Waste, IAPMO Listed

PAGE 1
PVC REGULAR CLEAR CEMENT TECHNICAL SPECIFICATION Job Name Item # Location Engineer Contractor PO # Tag Representative SPECIFICATIONS • Regular-Bodied Clear cement for use on all schedules and classes of PVC pipe and fittings up to 4" for Sch. 40 and up to 2" for Sch. 80. • Lo-V.O.C. Solvent Cement meets California South Coast Air Quality Management District (SCAQMD) 1168/316A or BAAQMD Method 40 and various environmental requirements.
PAGE 2
PVC REGULAR CLEAR CEMENT TECHNICAL SPECIFICATION DIRECTIONS PRECAUTIONS Store and use at temperatures between 40°F and 110°F. • At temperatures outside of this range, special care must be taken to make good joints. Stir or shake before using; if jelly-like, don’t use. Do not thin Read all information carefully before using this product. 1. Pipe ends must be cut square, deburred and chamfered. 2. Check interference fit of pipe and fitting. Pipe should easily go 1/3 to 2/3 of the way into the fitting.