Technical Specifications

Oatey Co. | 20600 Emerald Parkway, Cleveland, OH 44135 | 800.203.1155 | Oatey.com

Oatey Co. is part of the Oatey family of companies

Job Name Item #

Location

Engineer Contractor

PO # Tag

Representative

PVC FLEXIBLE

CLEAR CEMENT

TECHNICAL SPECIFICATION

8/19

VOC

Maximum VOC per SCAQMD 1168/316A or

BAAQMD Method 40: 510 g/L

CHEMICAL PROPERTIES

Appearance Clear Liquid

Viscosity Min. 500° cps @ 73° F ± 2° F

Density 7.69 ± 0.2 lbs/gallon

Shelf Life 3 Years from Mfg. Date

SET TIME / CURE TIME

30° F to 50° F 4 – 5 minutes

50° F to 70° F 3 – 4 minutes

70° F to 90° F 1 – 2 minutes

PRODUCT NUMBER SIZE DESCRIPTION CTN. QTY

30875 4 oz. PVC Flexible Clear Cement 12

30879 32 oz. PVC Flexible Clear Cement 12

SPECIFICATIONS

• Medium-bodied clear cement for use on ﬂexible PVC pipe and

rigid ﬁttings up to 6" diameter with interference ﬁt.

• Lo-V.O.C. Solvent Cement meets California South Coast Air Quality

Management District (SCAQMD) 1168/316A or BAAQMD Method

40 and various environmental requirements.

• Meets manufacturer’s rated line pressure for ﬂexible PVC pipe.

APPLICATION / USES

• Formulated to withstand pressures and vibrations commonly

associated with spa and swimming pool installations.

PROPERTIES

Compliant with LEED Requirements. Solvent cements may be speciﬁed

under the LEED v4 EQ for Low-Emitting Materials to obtain points

ASTM Standard D2564, NSF Standard 61 for DWV

and Sewer Waste, IAPMO Listed

PAGE 1
PVC FLEXIBLE CLEAR CEMENT TECHNICAL SPECIFICATION Job Name Item # Location Engineer Contractor PO # Tag Representative SPECIFICATIONS • Medium-bodied clear cement for use on flexible PVC pipe and rigid fittings up to 6" diameter with interference fit. • Lo-V.O.C. Solvent Cement meets California South Coast Air Quality Management District (SCAQMD) 1168/316A or BAAQMD Method 40 and various environmental requirements.
PAGE 2
PVC FLEXIBLE CLEAR CEMENT TECHNICAL SPECIFICATION DIRECTIONS PRECAUTIONS Store and use at temperatures between 40°F and 110°F. • At temperatures outside of this range, special care must be taken to make good joints. Stir or shake before using; if jelly-like, don’t use. Do not thin Read all information carefully before using this product. 1. Pipe ends must be cut square, deburred and chamfered. 2. Check interference fit of pipe and fitting. Pipe should easily go 1/3 to 2/3 of the way into the fitting.