Technical Specifications

Visit www.oatey.com for updates
TECHNICAL SPECIFICATION: Oatey No. 11 Liquid Flux is formulated with a strong cleaning agent to remove corrosion
quickly and effectively from surface of piping. Fluxing is a critical step in the soldering process. No. 11 Liquid Flux is lead-free
and is an ideal flux for use when soldering. No. 11 Liquid Flux complies with CA & VT lead content regulations.
No. 11
LIQUID FLUX
PRECAUTIONS
Read all cautions and directions carefully before using this
product. Apply flux with brush- do not apply with fingers.
Wash hands thoroughly after use and before eating. Wear
safety glasses with side shields and rubber gloves. EYE AND
SKIN IRRITANT. HARMFUL IF SWALLOWED. VAPOR MAY BE
HARMFUL. Eye or skin contact may cause intense irritation
and injury. In case of contact with eyes or skin, flush with
water and seek medical attention immediately. If swallowed,
DO NOT INDUCE VOMITING. Drink water and call physician
or poison control center immediately. Ingestion of this
product may cause gastrointestinal distress. If inhaled, get
fresh air and seek medical attention if ill feelings persist.
Keep container closed when not in use. DO NOT REUSE
EMPTY CONTAINER. KEEP OUT OF REACH OF CHILDREN.
Refer to material safety data sheet for more information.
For emergency first aid help, call 1-877-740-5015.
COMMON APPLICATIONS
Oatey No. 11 Liquid Flux can be used to solder most
commonly soldered metals including copper, brass, zinc,
galvanized iron and tin or copper-coated metals.
Consult Oatey Technical Department for applications not
specifically referenced above.
INGREDIENTS
Zinc Chloride (7646-85-7)
Ammonium Chloride (12125-02-9)
Water (7732-18-5)
Muriatic Acid (7647-01-0)
COMPLIANCE & LISTINGS
NSF Listed to Standard 61 Lead Free Flux
Complies to CA & VT
lead legislation
Meets Military Specification MIL
-
F
-
14256
PRODUCT
NUMBER
DESCRIPTION PACK CARTON WEIGHT
30106 4 oz. Liquid Flux 12 6 lbs.
1/2010
PHYSICAL/CHEMICAL PROPERTIES
Appearance Yellowish Liquid
Shelf Life 1 year from manufacture date
Boiling Point 208° F
pH 2 - 3
DIRECTIONS FOR USE
Paste Fluxes require only a small amount of flux applied
to the joint. Clean all surfaces before soldering. Apply
small amount of flux inside the fitting and outside of the
pipe. Heat to temperature required for soldering. Do not
overheat the piping. For small diameter piping, direct
the heat near the joint. For large diameter piping, move
the heat around the joint to ensure adequate solder flow
around the circumference of the joint. NOT FOR USE
WITH ALUMINUM, STAINLESS STEEL OR MAGNESIUM.
DO NOT USE ON ELECTRICAL PARTS.
When soldering process is complete, allow joint to cool
undisturbed. Remove any flux residual with a damp
cloth. Do not store Liquid Flux above 120° F.
C-3