ENHANCED OXYGEN SPRAY BOTTLE USER MANUAL Model: SB-100HD clean with the power of nature
CONTENTS 1 Safety ............................................................................................... 3 1.1 1.2 1.3 1.4 2 SAFETY Symbols from the User Manual ...................................... 3 Proper Use.............................................................................. 3 Caution .................................................................................... 3 Important Instructions.......................................................
SAFETY (cont’d) 1.4 IMPORTANT INSTRUCTIONS NOTICE To avoid appliance damage: Do not drop the bottle. – Dropping the bottle may cause breakage. Fill with clean potable water only. – Filling the bottle with fluids other than clean potable water may damabe cartridge and render the product useless. Do not overfill the bottle. – Overfilling may cause leakage at the fill plug. Do not run water into the charger port. – Doing so may short the battery/electronics.
Water Based Sanitizer • Proven sanitizer • Reduces common pathogens • Destroys odor-causing microorganisms • Ensures efficacy and compliance with EPA requirements DESCRIPTION 3.
Fill the Reservoir Remove the fill cap to fill the reservoir with 10 oz of clean, cold potable water. While holding the unit in the horizontal position, fill reservoir about half full. Securely replace the fill plug. Turn bottle in vertical position and check fill line. Repeat until water reaches fill line. Do not overfill. Do not fill with hot water. Sanitize Hard Non-Porous Surface Remove cap. Hold the spray bottle 6 to 8 inches from the surface and spray evenly until wet. For 99.
DECOMMISSIONING ( STORAGE / DISPOSAL ) 6.1 STORAGE Empty tank through the fill plug. Do not spray empty. Leave fill plug open to allow tank to dry. SERVICE 7.1 SERVICE & WARRANTY The manufacturer warrants new equipment to be free of defects due to poor materials or workmanship for the period of time listed below (following the date of original installation): • Disassembly of the appliance must be performed by qualified specialists according to the manufacturer’s instructions.
Distributed by: o3waterworks, LLC. 207 Byers Creek Road, Unit D Mooresville, NC 28117 Manufactured by: Enozo Technologies 300 Willow Street North Andover, MA 01845 EPA Est. No. 089373-MA-001 For support, contact: service@o3waterworks.