User Manual

User's guide O&O DiskImage Command specific parameter
Example
<is_superfloppy>yes</is_superfloppy>
label
Label of the selected drive based on the drive´s name.
Example
<label>System</label>
localname
The local name of the resource.
Example
<localname>Z</localname>
locates_bad_sectors_recover_readable_information
An investigation of bad sectors and the restoration of the readable data are requested.
Valid values: "yes", "no", "true" and "false"
Example
<locates_bad_sectors_recover_readable_information>yes
</locates_bad_sectors_recover_readable_information>
max_backup_size
Fixes the maximal size of the image file in bytes. A division will be made when this level is almost
reached.
Note: The minimum value of a backup file is 1 megabyte, or 1048576 bytes. If a value lower than
this amount is entered, the maximum size of the backup file will be set to 1 MB.
Example
<max_backup_size>786432000</max_backup_size>
new_comments
This parameter will let you add comments into the new image file.
Example
<new_comments>incremental image wg. Windowsupdate </new_comments>
max_image_size
Fixes the maximal size of the image file in bytes. A division will be made when this level is almost
reached.
Notes
The minimum value of an image file is 5 Megabyte, more exactly 5242880 bytes. If the value is
smaller than this, the maximal size of the image file will set at 5 MB.
Example
<max_image_size>786432000</max_image_size>
new_device_type
Indicates the type or description of the new target drive.
filesystem Standard – file system
Comment:
210 / 235