User Manual
User's guide O&O DiskImage Disk management functions
Example
<command name="create RAID5 volume">
<drivenumber>2</drivenumber>
<drivenumber>3</drivenumber>
<drivenumber>4</drivenumber>
<size>8589934592</size>
<RAID5_column_size>8589934592</RAID5_column_size>
<driveletter_to_set>R</driveletter_to_set>
</command>
create simple volume
Creates a simple volume.
Parameter
{ devicename | drivenumber | serialnumber }
{ size | complete_region_size | remaining_range | part_of_disk_size }
[ driveletter_to_set ]
Note
You can create simple volumes on dynamic volumes only.
Simple volumes are not error-tolerant.
You can install an operating system on a simple or mirrored dynamic volume only.Entries in the
partition table must exist for this volume (i.e., that this was a system or start volume).
Example
<command name="create simple volume">
<drivenumber>2</drivenumber>
<size>5368709120</size>
<driveletter_to_set>S</driveletter_to_set>
</command>
create spanned volume
Creates a spanned volume.
Parameter
size
{ devicename | drivenumber | serialnumber }
[ driveletter_to_set ]
191 / 235