User's Manual
Notice
Modification
Any modication (such as removing the speaker grill)
to the device, without prior authorization from the
manufacturer, may void your warranty and authority
to operate the device.
FCC compliance statement
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
•
Relocate the receiving antenna.
•
Increase the separation between the equipment
and receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la classe B est conforme
à la norme NMB-003 du Canada.
This device complies with FCC RF radiation exposure
limits set forth for an uncontrolled environment.
This equipment should be installed and operated
with a minimum distance of 20cm between the
radiator and your body.
This device and its antenna(s) must not be co-located
or conjunction with any other antenna or transmitter.
Recycling
Packaging
Observe the local regulations for how to dispose of
the packaging materials.
Instructions for Users on Removal, Recycling and Disposal of Used
Batteries
To remove the batteries from your equipment or
remote control, reverse the procedure described in
the owner’s manual for inserting batteries.
For products with a built-in battery that lasts for the
lifetime of the product, removal may not be possible
for the user. In this case, recycling or recovery centers
handle the dismantling of the product and the
removal of the battery. If, for any reason, it becomes
necessary to replace such a battery, this procedure
must be performed by authorized service centers. In
the European Union and other locations, it is illegal to
dispose of any battery with household trash. All batteries
must be disposed of in an environmentally sound
manner. Contact your local waste-management ofcials
for information regarding the environmentally sound
collection, recycling and disposal of used batteries.
WARNING: Danger of explosion if battery is
incorrectly replaced. To reduce risk of re or burns,
don’t disassemble, crush, puncture, short external
contacts, expose to temperature above 60°C
(140°F), or dispose of in re or water. Replace only
with specied batteries.
The symbol indicating ‘separate collection’ for all
batteries and accumulators shall be the crossedout
wheeled bin shown below:
In case of batteries, accumulators and button cells
containing more than 0.0005 % mercury, more than
0.002 % cadmium or more than 0.004 % lead, shall
be marked with the chemical symbol for the metal
concerned: Hg, Cd or Pb respectively. Please Refer
to the below symbol:
Copyright
The Bluetooth word mark and logos are owned by
the Bluetooth SIG, Inc. and any use of such marks by
Nyne Multimedia Inc. is under license.
Specifications
The technical specications are subject to change
without prior notice.
DC power input
DC 5V 2A
Speaker drivers 2 x 3.5 inches
S/N >70dB
THD+N <10%
Dimension 13.74 (W) x 6.69 (H) x 7.16 (D)
inches
Weight 2.11 kg
Audio input 1 x 3.5 mm socket
1 x wireless input (Bluetooth)
Wireless Bluetooth 2.1 + EDR (Class 2)
Bluetooth proles HFP, A2DP, AVRCP
Battery capacity 7.4V 2200mAh
Battery type Lithium-ion
Play time 10 - 12 hours
EN
Important
Safety
The lightning ash with arrowhead
symbol within an equilateral triangle
is intended to alert the user to the
presence of un-isolated, dangerous
voltage within the inside of the device
that may be of sufcient magnitude
to constitute a risk of electric shock to persons.
Warning: To reduce the risk of electric shock, do
not remove cover (or back) as there are no user-
serviceable parts inside. Refer servicing to qualied
personnel.
The exclamation point within an
equilateral triangle is intended
to alert the user to the presence
of important operating and
servicing instructions in the literature
accompanying the device.
WARNING: To reduce the risk of re or electric shock,
do not expose this apparatus to rain or moisture.
The apparatus shall not be exposed to dripping or
splashing and that objects lled with liquids, such as
vases, shall not be placed on apparatus.
WARNING: Where the mains plug/appliance coupler
is used as the disconnect device, the disconnect
device shall remain readily operable.
WARNING: The battery (battery or batteries or
battery pack)
shall not be exposed to excessive heat
such as sunshine, re or the like.
Read these instructions before operation.
Keep these instructions for future reference.
Follow all instructions for installation, use and
maintenance of the device.
To clean the device, disconnect power rst. Clean
only with soft and dry cloth.
To ensure compatibility, only use accessories
recommended by the manufacturer.
When the device is suddenly moved from cold
to warm surroundings, condensation may form in
the housing of the device. Before use, leave the
device in the warm environment until the moisture
evaporates.
Keep the device away from heat sources, such as
a radiator, heater, oven, amplier, naked ames or
direct sunlight.
No naked ame sources, such as lighted candles,
should be placed on the apparatus.
Never block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
•
Do not expose the device to sand or dust, or
cover it with items, such as newspapers, table
cloths, or curtains.
•
Do not operate the device in an enclosed
cabinet. Leave sufcient free space around the
device for adequate ventilation.
Do not attempt to repair or service the device
yourself. Opening or removing the cabinet may
expose you to electric shock, and other hazards. If
repair is required, contact your dealer and refer all
servicing to qualied service personnel.
Do not use the device if any abnormality occurs. If
any smoke or odor becomes apparent, contact your
dealer immediately. Do not try to repair the device
yourself.
Avoid using dropped or damaged appliances. If the
device is dropped and the housing is damaged, the
internal components may not function normally. Stop
use and contact your dealer for repair. Continued
use of the device may cause re or electric shock.
To reduce the risk of electric shock, do not touch any
connector with wet hands.
Never remove the housing of the device.
Never lubricate any part of the device.
Never place the device on top of any other
electrical equipment.
This equipment is a Class II or double insulated
electrical appliance. It has been designed in such a
way that it does not require a safety connection to
electrical earth.
EN
Charge your mobile device through the 5V 1A
charging socket.
ES
Cargue su dispositivo móvil por medio de la
entrada de carga de 5 V y 1 A.
NYNE Adventure - QUG_V1.0_20170606.indd 5-8 6/6/2017 3:57:57 PM
FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.