Tus neeg siv phau ntawv
Please keep this User Manual for future
another user, be sure that they also receive
this instruction booklet.
Unpack and check carefully there is no
transportation damage before using the
Before operating, ensure that the voltage
and frequency of power supply match the
It’s important to ground the yellow/green
conductor to earth in order to avoid electric
shock.
Disconnect main power before servicing
and maintenance.
only, but always by taking its base.
WARNING! The Logo 200W IP65 has a powerful pan motor. The torque reaction when the
a surface. Do not apply power to the Logo 200W IP65 unless the baase is securely fastened to
a surface or to rigging hardware.
WARNING!
Lock each clamp with both 1/4-turn fasteners. Fasteners are locked only when turned a full
90 clockwise.
WARNING!
with the yoke hanging vertically downwards, use two clamps of half-coupler type. Do not
use any type of clamp that does not completely encircle the structure when fastened.
WARNING!
or any other strong light source from any angle - even for a few seconds. See Figure 2. The
Logo 200W IP65 lens can focused the sun's rays, creating a potential fire hazard and causing
damage.
IMPORTANT!Logo 200W IP65,
as intense illumination can damaged the display.
Don’t operate it where the temperature is
higher than this.
In the event of serious operating problem,
carried out by unskilled people can lead to
damage or malfunction. Please contact the
nearest authorized technical assistance
center. Always use the same type spare
parts.
Do not connect the device to any dimmer
pack.
Do not touch any wire during operation
and there might be a hazard of electric
shock.
To prevent or reduce the risk of electrical
rain or moisture.
visibly damaged.
Do not look directly at the LED light spot
2. SAFETY INFORMATION
1. INTRODUCTION
Logo 200W IP65
WARNING!
User Manual •Instrukcja Obsługi
Figure 2.