Warranty

Installation
Installations(refer to Page 4 for parts):
1.Measure the distance between stove top and the bottom of range hood.A distance of “27 to 30" is recommended*Due to
difference ceiling height configurations,recommended height may not be applicable.
1.You have two ways(Aor B)to mount this range hood:
A-1.Proceed if you would like to mount this range hood without using the hood-mounting bracket.
A-2.Using references in Height&Clearance on Page 5 and Measurements and Diagrams on Page 16,center the hood beneath the
cabinet and flush with the front of the cabinet.
A-3.From inside of the hood,place screws into the exact center of each knockout hole and secure to cabinet bottom.Finish
Fightening all screws until secure.Be careful when using clectrical screwdriver,damage to the range hood may occur.Skip Part
B below and proceed to Step 2.
CAUTION:Make certain the range hood is secure before releasing!
B-1.Proceed if you would like to mount this range hood using the provided hood-mounting bracket.
B-2.Using references in Height&Clearance on Page 5 and Measurements and Diagrams on Page 17,mark the leveling point of
the hood.Position two mounting screws on the wall,leaving 1/8" space away from the wall.Mounting the hood on wall studs or
lumbars is highly recommended.
B-3.Attach each hood-mounting bracket to the back of the hood with 4 flat head screws as shown in Figure 5.
B-4.Align hood-mounting bracket to the screws on the wall and hook hood into place as shown in Figure 6.Tighten screws to
screws to secure hood to the wall.
CAUTION:Make certain the range hood is secure before releasing!
2.For safety purpose,pre-drilled mounting holes are provided through the back of the hood.For a more secure installation,use
as many mounting holes as needed to secure from the inside of hood.
3.Use 8"round steel pipe(follow building codes in your area) to connect the exhaust on the hood to the duct-work above.Use
silver tape or duct tape to make all joints secure and air tight.Refer to Figure 7.
SAFETY WARNING:Risk of electrical shock.this range hood must be properly grounded.Make sure this is done by
qualified electrician in accordance with all applicable national and local electrical codes.Before connecting wires,switch
power off at service panel and lock service panel to prevent power from being switched on accidentally.
11
Range Hood Operations(Continued)
Q
I
I
I
I
LED Light
Indicator
Light Control
Decrease
Speed
Increase
Speed
LED Speed
Indicator
Power Control
(On/Off)
Control Panel Layout and Buttons Configurations:
During this 3-minutes delay,changing speeds will not affect the countdown.
Immediate Power-off
While the fans are in 3-minute power-off delay mode,press the Power Control(on/Off)button once to turn OFF the fans immediately.
When the fans are operating in normal mode(LED Speed Indicator not flashing),press the Power Control (On/Off)twice to turn OFF the fans.
Light Control:
Light Control button operates independently from the Power Control(On/Off) and power-off delay function.
Pressing the Power Control(On/Off)button or activating the dealy function will not turn halogen lights ON or OFF.CAUTION:DO NOT
touch the lights until switched OFF and cooled.
While the halogen lights are OFF,press the Light Control button once to turn halogen lights on.LED Light indicator will light up.
Touch the Light Control button again will change the light intensity to Low.
Each touch of the Light Control button will cycle the light intensity through High,Low and OFF.
14