Duro Corporation Gas Range Manual for Installation, Care & Maintenance DRGB3001 DRGB3601 DRGB3602 WD03122008
Thank you for purchasing your NXR indoor range. We appreciate your business and we recommend that you read this entire user’s manual before operating your new appliance for the first time. This manual contains instructions on how to properly install and set up your new range, as well as insights into many of the unique features that our product offers. Please keep this manual for future reference, as it contains the answers to questions that you might have as you begin to cook.
Contents Safety Instructions ……………………………………………………………. 1 Installation Instructions ………………………………………………………. 2~8 Cooktop Operation …………………………………………………………… 9~11 Oven Operation ………………………………………………………………. 12 Broiler Operation ……………………………………………………………... 13 Griddle Operation …………………………………………………………….. 14 Care & Cleaning ……………………………………………………………… 15~16 Troubleshooting ………………………………………………………………. 17 Warranty & Product Registration ……………………………………………..
Installation ! WARNING All ranges can tip and cause injuries. Install anti-tip device packaged with range. Follow all Installation Instructions. Make sure the anti-tip bracket is installed: Slide range forward. Make sure the anti-tip bracket is securely attached to the wall behind the range. Safely tilt the front of the range upward slightly and move back against wall, Making sure the pin slides under bracket.
Installation To ensure proper and safe operation, read all instructions before using the product. Install or locate the product only in accordance with the provided Installation Instructions. • Do not attempt to adjust, repair, service, or replace any part of your appliance unless it is specifically recommended in this guide. • Do not use the range for warming or heating the room. • Do not leave children along or unattended in the area where the range is in use.
Installation Gas Supply Requirements I t ll ti off this Installation thi range mustt conform f with ith local l l codes, d or in i the th absence b off local l l codes, d than th national Fuel Gas Code, ANSIZ223.1 / NFPA 54. In Canada, installation must conform to the current natural Gas Installation /code, CAN 1-1.1-M81 and with local codes where applicable. This range has been design-certified according to ANSIZ21.1-2005, latest edition. MAXIMUM GAS SUPPLY PRESSURE TO APPLIANCE ---14.0 IN.W.C.
Installation Dimensions and Clearances The range may be installed flush to the rear wall. You may install a non-combustible material on the rear wall above the range and up to the vent hood. It is not necessary to install non-combustible materials behind the range below the counter top height. The minimum distance from the side of the range above the counter top to combustible sidewalls must be at least 10 inches.
Installation Dimensions and Clearances 6
Installation Electric Power Supply pp y Requirements q Your range must be electrically grounded in accordance with local codes or, in the absence of local codes, in accordance with the National Electrical Code (ANSI/NFPA 70, latest edition). In Canada, electrical grounding must be in accordance with the current CSA C22.1 Canadian Electrical Code Part 1 and/or local codes.
Installation 5. When all connections have been made, make sure all range controls are in the “off” position and turn on main gas supply valve. valve 6. Use a leak detector at all joints and connections to check for leaks in the system. Do not use a flame to check for gas leaks. The appliance must be isolated from the building’s gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas supply piping system at test pressure equal to or less than ½ psig (3.
Cooktop Operation Surface Burner Ignition Push to release gas. Turn to ‘Hi’ position. Adjust to appropriate flame height. To light the surface burners, push and turn the appropriate control knob counter clockwise to a “Hi” position. You will hear a clicking noise – the sound of the electric spark igniting the burner. Once burner ignition has been achieved, turn the burner control knob to adjust the flame size. If the knob stays at “Hi”, Hi , it will continue to click.
Cooktop Operation Simmer and Boil • A smaller flame will give the best simmer results. results Small flames offer precise cooking performance for delicate foods, keeping food warm, melting chocolate or butter, and for cooking that need to cook over low heat for a long time. • The highest (larger) flame settings provide the maximum heat that is available on your range. This setting should be used for heavy cooking loads such as water boiling and pasta cooking.
Cooktop Operation Oven Vent • Do not block the ducts at the rear of the range when cooking in the oven. It is important that the flow of hot air from the oven and fresh air into the oven burner never be interrupted. Avoid touching the vent opening or nearby surfaces during oven or broiler operation – they may become hot. Burner Grates 1. The grates must be properly positioned before cooking. Improper installation of the grates may result in scratching of the cooktop and / or poor combustion. 2.
Oven Operation Oven Function Natural Airflow Bake occurs when heat is transferred into the oven from the bake burners in the bottom of the oven cavity. Heat is then circulated by natural airflow. This is a traditional bake setting. Infrared Broil The broil burner is located at the top of the oven. This burner heats the metal screen until it glows. The glowing screen produces the infrared heat, searing the outside of broiled foods and sealing in juices.
Broiler Operation Note: Door must be closed during broiling operation. Broiling is a method of cooking tender cuts of meat directly under the infrared broiler in the oven . Broiling in the oven is accomplished with the oven door closed. It is normal and necessary for some smoke to be present to give the food a broiled flavor. Preheating Preheating is suggested when searing rare steaks (Remove the broiler pan before preheating with the infrared broiler. Foods will stick on hot metal).
Griddle Operation Before Using the Griddle 1. Clean the griddle thoroughly with warm, soapy water to remove dust or any protective coating. 2. Rinse with clean water and wipe off to dry with soft, clean, lint-free towel/cloth. 3. A stainless steel cover that is sized to fit on top of the surface when the griddle is not being used is provided. Please note – the cover must be removed before turning the griddle on. 4. Make sure the grease tray is under the front edge of the griddle.
Care and Cleaning Cooktop • To avoid electrical shock or burns, turn off all controls and ensure the cooktop is cool before cleaning. • Before cleaning the cooktop, ensure that all burners are turned off and that all components are cool enough to safely touch. • Do not use harsh or abrasive cleaning agents, waxes, polishes, or commercial cooktop cleaners to clean the cooktop. • Use only a sponge, soft cloth, fibrous or plastic brush, and nylon pad for cleaning.
Care and Cleaning Metal Finishes • Wash with soap and water, glass cleaner, or mild liquid sprays. Plastic Finishes • When control panel trim and end caps are cool, clean with soap and water, rinse and dry. • Use a glass cleaner and soft cloth. Oven Racks • Clean Stainless steel oven racks with solution of detergent and hot water. water To clean heavy soil, use a scouring pad such as steel wool with plenty of water. Oven Frame • Clean with hot water, soap-filled steel-wool pads or cleaners.
Troubleshooting Before you call for service, please review the potential problem / possible causes and remedies shown in the table below. Nothing works Oven is not connected to the electrical power. Have oven connected to a properly sized electrical power supply by a qualified electrician. Power supply is not energized. Have an electrician check the power supply, including the house circuit breaker, wiring and fuses Plug on range is not completely inserted in the electrical outlet.
Manufacture’s Limited Warranty This Product has been manufactured by Duro Corporation 280 Machlin Court, City of Industry, CA 91789. Duro Corporation disclaims all express warranties except for the following: This warranty applies to products purchased and located in the United States. Products purchased or located outside these areas are excluded.
Warranty Duro is not responsible for incidental or consequential damages. Under no circumstances will Duro’s liability exceed the cost that you paid for the product. Some provinces/states do not allow the exclusion or limitation of incidental or consequential damages, damages so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state.
