Instructions / Assembly

7
Cabinet Cutout Dimensions
The illustration below includes cutout dimensions and minimum spacing requirements. The illustration is for reference. The design of
your cabinet layout can be personalized, but the dimensions for the cutouts and minimum spacing must be followed.
Center or support surfaces must be level.
Built-in Outdoor Grill Enclosure Ventilation Requirements
（
see picture 1
）
Any enclosure is to be ventilated by openings at both the top and lower levels of the enclosure. The following information is the minimum for
proper ventilation of your island construction. There should be a minimum of 1⁷⁄₈” (4.4 cm) of clearance from the bottom of the grease tray and
the front wall of the island for proper ventilation.
NOTE: There should be no solid surface underneath the firebox portion of the grill. A minimum of 3” (7.6 cm) is required between the back of the grill
and noncombustible materials should be used.(see picture 2)
Any enclosure for built-in installation is to have at least below 2 openings:
Hole A: (see picture 1)
Top openings: At least two equally sized ventilation openings shall be provided in the side walls of the enclosure, located within 5 in of the top of
the enclosure, spaced at a minimum of 90 degrees and unobstructed. The openings shall have a total free area of not less than 20 in
2
.
Hole B: (see picture 1)
Floor level openings: At least two equally sized ventilation openings shall be provided in the side walls of the enclosure, the bottom of the openings
shall be 1 inch or less from the floor level and the upper edge no more than 5 inches above the floor level,
spaced at a minimum of 90 degrees and unobstructed. The openings shall have a total free area of not less than 10 in
2.
.
Every opening shall have a minimum dimension so as to permit the entrance of a 3.2mm rod. Proper ventilation is a required based on the
above mentioned specifications for your grill to operate properly.
Picture 1
Picture 2
1
3
3"
1
2

3
/
4
"
22"
173/8"
24"
65"
181/2"
43/4"
1
8

1
/
2
"
1
"
5
"
5
"
8"
1
.
5
"
8"
5
"
17"
Cylinders
baffler