Instructions / Assembly

STEP FIVE: Connecting the NG hose

IMPORTANT:

The supply line shall be equipped with an approved

shutoff valve. This valve should be located in the same area as the grill

and should be in a location that allows ease of opening and closing. Do

not block access to the shutoff valve. The valve is for turning on or

shutting off gas to the grill.

Connect the 6 inch NG regulator kit hose that come with the NG

regulator（NG part3） to the grill（picture 1）. Check that the Natural gas

pressure regulator is positioned in the encloser that the LP gas tank

stays and make sure it is not pinched or kinked.

2. Connect the brass connector of the 10 ft (3.0 m) PVC flexible gas

supply hose (NG part 4) to the Natural gas pressure regulator.

NOTE: the 10 ft(3.0m) PVC flexible gas supply hose design-certified by

CSA must be used. Pipe-joint quick connector suitable for Nature gas

must be use. Do not use Teflon tape.

3. Install the QDD to the NG supply pipe by a qualified gas technician.

4 Connect the the 10 ft (3.0 m) PVC flexible gas supply hose to the rigid

Natural

gas supply pipe（picture 2）

Warning: NG Convers

ion must be installed by a qualified gas

technician.

A. 10 ft hose (NG part 4)

B. Quick connector (together with Ng part 4)

C. NG regulator(NG part 3)

Picture 2

Picture 1