Instructions / Assembly

Grill INSTALLATION INSTRUCTIONS
Un
pack
G
rill
WARNING
Excessive Weight Hazard
Use two or more people to move and install grill.
Failure to do so can result in back or other injury.
Unpack Grill
1. Remove all packaging materials and remove grill from the
shipping base.
2. Move grill close to desired outdoor location.
3. Open the grill hood.
4. Check all the parts are well packaged and kept in the right place, then
remove foam block and wrap from inside the box.
5. Replace the flame tamers, grill grates and warming rack.
6. Place all the parts to the correct location as picture. below
7.loose the screws and nuts below picture 1 and use the 2 screws to lock
the back panel
Use 5pc
s
M
5X10 screws(these 5 pcs screws already pre-assembled on the fire
box side panel,please take down before lock the side trims) to lock both left and right
trims to the firebox sides separately as pic(2). below
8. Using 4pcs M5X10 screws
(these 4 pcs screws already pre-assembled
on the fire box back panel,please take down before lock the back trim)
to lock the back trim to the back side of firebox as pic. below
Install Grill
NOTE: The grill drops into the enclosure and is supported by its side
flanges. Do not use a bottom support.
1. Place grill into outdoor enclosure, leave enough room in the back to
connect to the gas supply.
2. Before connecting to the Hose Assembly, please install the connecting
rigid pipe, semi-rigid tubing ( see the requirement of page 9: LP gas
Connecting system).
3.Connect the regid pipe or semi-regid tubing to the LP regulator/Hose
assembly. make sure the LP regulator/Hose assemble is under the grill not
being pressed by the grill.
4. Check that the LP gas pressure regulator/hose assembly is not pinched
or kinked and positioned in the encloser that the Gas tank stays.
5. Where the connector or tubing passes through openings in cabinets, or
openings in the built-in enclosure, protecting the tubing or connector as
it passes through openings in a compartment in the built-in enclosure.
6. supporting the piping, flexible tubing, or gas connector within the built-in
enclosure and ensure the visibility of the connector through a door
opening or a window opening in the enclosure.
11
To Connect the 20 lb LP Gas Fuel Tank:
1. C
heck that the 20 lb LP gas fuel tank is in the “Off” position. If
not, turn the valve clockwise until it stops.
2. Check that the 20 lb LP gas fuel tank valve has the proper
type-1 external male thread connections per ANSI Z21.81.
3. Check that the burner control knobs are in the “Off” position.
4. Remove any debris and inspect the valve connections, port,
and gas pressure regulator/hose assembly for damage.
5. Using your hand, turn the gas pressure regulator/hose
assembly clockwise to connect to the 20 lb LP gas fuel tank
as shown. Hand tighten only. Use of a wrench could damage the
quick coupling nut.
6. Open the tank valve fully by turning the valve counterclockwise. Wait
a few minutes for gas to move through the gas line.
A. Gas pressure regulator/hose assembly
B. 20 lb LP gas fuel tank
Picture 1 Picture 2