Datasheet

Table 40. Revision History
Rev. No. Date Substantial Changes
• Added footnotes V
ih
Input Buffer High Voltage and V
ih
Input Buffer Low
Voltage
• Updated table: AC electrical specifications at 3.3 V range
• Updated table: AC electrical specifications at 5 V range
• In table: Standard input pin capacitance
• Added footnote to Normal run mode (S32K14x series)
• Removed note from 1M ohms Feedback Resistor in figure Oscillator
connections scheme
• In table: External System Oscillator electrical specifications
• Updated typical of I
DDOSC
Supply current — low-gain mode (low-power
mode) (HGO=0) 1 for 4 and 8 MHz
• Removed rows for I
lk_ext
EXTAL/XTAL impedence High-frequency, low-
gain mode (low-power mode) and high-frequency, high-gain mode and
V
EXTAL
• Updated Typ. of R
S
low-gain mode
• Updated description of R
F
, R
S
, and V
PP
• Removed footnote from R
F
Feedback resistor
• Updated footnote for C
1
C
2
and R
F
• In table: Table 16
• Removed mention of high-frequency
• Added HGO 0, 1 information
• In table: Fast internal RC Oscillator electrical specifications
• Updated F
FIRC
• Updated description of ΔF
• Updated typ and max values of T
JIT
cycle-to-cycle jitter and T
JIT
Long
term jitter over 1000 cycles
• Added footnotes to T
JIT
cycle-to-cycle jitter and T
JIT
Long term jitter
over 1000 cycles
• Updated naming convention of I
DDFIRC
Supply current
• Added footnote to I
DDFIRC
Supply current
• Added footnote to column Parameter
• In table: Slow internal RC oscillator (SIRC) electrical specifications
• Removed V
DD
Supply current in 2 MHz Mode
• Removed footnote and updated description of ΔF
• Updated footnote to F
SIRC
and I
DDSIRC
• In table: SPLL electrical specifications
• Added row for F
SPLL_REF
PLL Reference
• Updated naming convention throughout the table
• Updated the max value of T
SPLL_LOCK
Lock detector detection time
• In table: Table 21
• Added footnotes:
• All command times assumes ...
• For all EEPROM Emulation terms ...
• 'First time' EERAM writes after a POR ...
• Removed footnote 'Assumes 25 MHz or ...'
• Updated Max of t
eewr32bers
• Added parameters t
quickwr
and t
quickwrClnup
• In table: Table 22
• Removed Typ. values for all parameters
• Removed footnote 'Typical values represent ... '
• Added footnote 'Any other EEE driver usage ... '
• Updated QuadSPI AC specifications
• Removed topic: Reliability, Safety and Security modules
• In table: 12-bit ADC operating conditions
• Updated V
DDA
Table continues on the next page...
Revision History
S32K1xx Data Sheet, Rev. 4, 06/2017
NXP Semiconductors
Preliminary
67