Datasheet

Table 6. Power mode transition operating behaviors (continued)
Symbol Description Min. Typ. Max. Unit
VLPS → RUN 8 — 17 μs
STOP1 → RUN 0.07 0.075 0.08 μs
STOP2 → RUN 0.07 0.075 0.08 μs
VLPR → RUN 19 — 26 μs
VLPR → VLPS 5.75 6.25 6.5 μs
VLPS → VLPR 26.5 27.25 27.75 μs
RUN → Compute operation 0.35 0.38 0.4 μs
HSRUN → Compute operation 0.3 0.31 0.35 μs
RUN → STOP1 0.35 0.38 0.4 μs
RUN → STOP2 0.2 0.23 0.25 μs
RUN → VLPS 0.35 0.38 0.4 μs
RUN → VLPR 4.4 4.7 5 μs
VLPS → Asynchronous DMA Wakeup 105 110 125 μs
STOP1 → Asynchronous DMA Wakeup 1 1.1 1.3 μs
STOP2 → Asynchronous DMA Wakeup 1 1.1 1.3 μs
Pin reset → Code execution — 214 — μs
NOTE
HSRUN should only be used when frequencies in excess of 80
MHz are required. When using 80 MHz and below, RUN mode
is the recommended operating mode.
4.7
Power consumption
The following table shows the power consumption targets for the device in various mode
of operations.
General
S32K1xx Data Sheet, Rev. 4, 06/2017
NXP Semiconductors
Preliminary
15