Datasheet

EXTERNAL USE
19
Introduction to OpenSDA: 1 of 2
OpenSDA is an open-standard serial and debug adapter. It bridges serial and debug communications between a USB host and an
embedded target processor. OpenSDA software includes a flash-resident USB mass-storage device (MSD) bootloader and a
collection of OpenSDA Applications. S32K118 EVB comes with the MSD Flash Programmer OpenSDA Application preinstalled.
Follow these instructions to run the OpenSDA Bootloader and update or change the installed OpenSDA Application.
IMPORTANT NOTE: Follow the “Load an OpenSDA
Application” instructions to update the MSD Flash
Programmer on your S32K118 EVB to the latest
version.
Enter OpenSDA Bootloader Mode
1. Unplug the USB cable if attached
2. Set J104 on position 1-2.
3. Press and hold the Reset button (SW5)
4. Plug in a USB cable (not included) between a
USB host and the OpenSDA USB connector
(labeled “SDA”)
5. Release the Reset button
A removable drive should now be visible in the host
file system with a volume label of BOOTLOADER.
You are now in OpenSDA Bootloader mode.
Load an OpenSDA Application
1. While in OpenSDA Bootloader mode, double-click
SDA_INFO.HTML in the BOOTLOADER drive. A web
browser will open the OpenSDA homepage containing the
name and version of the installed Application. This
information can also be read as text directly from
SDA_INFO.HTML
2. Locate the OpenSDA Applications
3. Copy & paste or drag & drop the MSD Flash Programmer
Application to the BOOTLOADER drive
4. Unplug the USB cable and plug it in again. The new
OpenSDA Application should now be running and a
S32K118 EVB drive should be visible in the host file system
You are now running the latest version of the MSD Flash
Programmer. Use this same procedure to load other OpenSDA
Applications.