Datasheet

EXTERNAL USE
13
Power up the EVB board
 Powers the S32K116EVB evaluation board from a
USB. By default, the USB power is enabled by J07
jumper.
 Connect the USB cable to a PC and connect micro
USB connector of the USB cable to micro-B port J7
on the S32K116EVB.
 Allow the PC to automatically configure the USB
drivers if needed.
 When EVB is powered from USB, LEDs D2 and D3
should light green.
 The EVB board is preloaded with a software
toggling the RGB LED colors periodically between
RED-GREEN-BLUE.