User guide

16-bit MCU: S12XHY256 Automotive Cluster Demo, Rev. 0
Preliminary—Subject to Change Without Notice
How to setup and operate the demo board
Freescale Semiconductor2
Figure 1. S12XHY dashboard cluster demo board
2 How to setup and operate the demo board
The demo is very straightforward to setup. It requires a 12 volt DC supply, which is connected at the
bottom right side of the board as shown in Figure 1. Switch 5 should be set to the on position (This demo
does not use switch 4, ignition switch, so it can be in any state). The demo will then start automatically in
the initiation phase, as described below, and all motors will return-to-zero all at once.