Datasheet

S12 MagniV Mixed-Signal MCUs
Jumper Description
J11
Routing of PWM0-1, ETRIG0-1, HALL_SENSOR, GPIO0-1 and IRQ_N to Header J15.
Jumper pin 1-2 closed routes PWM0 - ETRIG0 to CON_PWM0 pin 4 on Header J15
Jumper pin 2-3 closed routes PWM0 - ETRIG0 to CON_ETRIG0 pin 6 on Header J15
Jumper pin 4-5 closed routes PWM1 - ETRIG1 to CON_PWM1 pin 5 on Header J15
Jumper pin 5-6 closed routes PWM1 - ETRIG1 to CON_ETRIG1 pin 7 on Header J15
Jumper pin 7-8 closed routes HALL_SENSOR - GPIO1 to CON_HALL_SENSOR pin 8 on Header J15
Jumper pin 8-9 closed routes HALL_SENSOR - GPIO1 to CON_GPIO1 pin 11 on Header J15
Jumper pin 10-11 closed routes IRQ_N - GPIO2 to CON_IRQ_N pin 9 on Header J15 and DNP Pull up resistor
Jumper pin 11-12 closed routes IRQ_N - GPIO2 to CON_GPIO2 pin 12 on Header J15
J20
MCU 5 Volts Output
The jumper closed enables to supply the 5 Volts circuitry using the 5 Volts MCU regulated output
J21
Low-Side Driver 0 to LED Output
Closing thejumper the low-side driver is routed to LED D5
J22
Low-Side Driver 1 to LED Output
Closing the jumper the low-side driver 1 is routed to LED D6
J23
High-Side Driver 0 to LED Output
Closing the jumper the high-side driver 0 is routed to LED D7
J24
High-Side Driver 1 to LED Output
Closing the jumper the high-side driver 0 is routed to LED D8