Datasheet

Quick Start Guide
S12VR64EVB Jumper List and Description–continued...
Jumper Description
J3
Analog Inputs/Port AD/Keyboard Wake Up
Analog Inputs – The jumpers are used to route the Potentiometer R2 to the ADC’s analog inputs
Jumper pins 1-2 closed - AN0 to Potentiometer R2
Jumper pins 3-4 closed - AN1 to Potentiometer R2
Jumper pins 5-6 closed - AN2 to Potentiometer R2
Jumper pins 7-8 closed - AN3 to Potentiometer R2
Jumper pins 9-10 closed - AN4 to Potentiometer R2
Jumper pins 11-12 closed - AN5 to Potentiometer R2
J8 OSBDM - Jumper closed is used to enter in boot-loader mode
J9 Jumpers to energize the relay load. It is needed to have all the jumpers closed
J10
Routing of TIMER0-3, LINPHY and GPIO0 to J15 Header Connector and LEDs D10 to D13
Jumper pin 1-2 closed routes TIMER0 GPI0 to LED D13
Jumper pin 2-3 closed routes TIMER0 GPI0 to CON_GPIO0 on Header Connector J15
Jumper pin 4-5 closed routes TIMER1 LINPHY_REG to LED D12
Jumper pin 5-6 closed routes TIMER1 LINPHY_REG to CON_LINPHY_REG on Header Connector J15
Jumper pin 7-8 closed routes TIMER2 LINPHY_RXD to LED D11
Jumper pin 8-9 closed routes TIMER2 LINPHY_RXD to CON_LINPHY_RXD pin 2 on Header Connector J15
Jumper pin 10-11 closed routes TIMER3 LINPHY_TXD to LED D10
Jumper pin 11-12 closed routes TIMER3 LINPHY_TXD to CON_LINPHY_TXD pin 3 on Header Connector J15
Jumper pin 13-14-15 not connected