Datasheet

www.nxp.com

STEP-BY-STEP INSTRUCTIONS

1. Connect the S08PT60-EVK to a PC using the included micro USB cable to power/

OSBDM micro USB connectors (J7) of S08PT60-EVK board. A green LED (D5) will

illuminate, indicating power is on.

2. The S08PT60-EVK comes pre-programmed with a demo which leverages the on-board

accelerometer. When the board is lying flat, the RGB LED (D1) is turned off. When the

board is tilted, the red or blue LEDs will gradually illuminate based on the degree

of tilt.

3. J6 is the BDM header which can be used to debug/program S08PT60 by the debugger

P&E Multilink FX or P&E Multilink.

4. J5 must be open when using P&E Multilink FX to supply power and debug/program

S08PT60.

5. Explore more out-of-box demos and download software and tools at