Quick Start Guide S08PT60-EVK
Quick Start Guide GET TO KNOW THE S08PT60-EVK D5 Power/OSBDM Micro USB J13 JM60 BDM Header SW1 Reset J2 Header J6 PT60 BDM Header J5 J3 Header S08PT60 J4 Header J1 Header Thermistor Accelerometer/ Magnetometer D1 RGB LED SW3 NC-2 P3V3-4 PTA5-6 P3V3-8 P5V-10 GND-12 GND-14 P5V_MC_IN-16 1-PTC5 3-PTC4 5-PTB5 7-PTB4 9-PTD1 11-PTD0 13-PTH1 15-PTH0 PTF4-2 PTF5-4 PTF6-6 PTF7-8 PTA6-10 PTA7-12 1-PTB3 3-PTC0 5-PTD2 7-PTD3 9-PTF0 11-PTF1 GND-19 PTB2-17 PTB0-15 PTC7-13 PTC6-11 PTC1-9 PTA7-7 PTA6-5 PTA1-3
www.nxp.com STEP-BY-STEP INSTRUCTIONS 1. Connect the S08PT60-EVK to a PC using the included micro USB cable to power/ OSBDM micro USB connectors (J7) of S08PT60-EVK board. A green LED (D5) will illuminate, indicating power is on. 2. The S08PT60-EVK comes pre-programmed with a demo which leverages the on-board accelerometer. When the board is lying flat, the RGB LED (D1) is turned off. When the board is tilted, the red or blue LEDs will gradually illuminate based on the degree of tilt. 3.
SUPPORT Visit www.nxp.com/support for a list of phone numbers within your region. WARRANTY Get Started Download installation software and documentation at www.nxp.com/S08PT60-EVK. Visit www.nxp.com/warranty for complete warranty information. www.nxp.com NXP and the NXP logo are trademarks of NXP B.V. All other product or service names are the property of their respective owners. © 2019 NXP B.V.
