Datasheet

ManualsBrandsNXP ManualsDevelopment Boards & KitsDevelopment Kit for PN7150 Plug and Play NFC Controller

NXP Semiconductors

UM10935

PN7150 NFC Controller SBC Kit User Manual

UM10935

All information provided in this document is subject to legal disclaimers.

User manual

COMPANY PUBLIC

Rev. 1.1 — 18 May 2016

348011

18 of 23

5. Federal Communication Commission Interference Statement

5.1 FCC Grant

The PN7150 NFC Controller Board have been tested to fulfil the approval requirements

FCC 47 CFR part 15: 2014 (§15.225).

The related FCCID is: OWROM5578-PN7150S

5.2 Installation instructions

PN7150 NFC Controller board can then be reused as a module for integration into end

devices following below instruction/restrictions:

• The module is limited to OEM installation ONLY

• The OEM/Integrators are responsible for ensuring that the end-user has no

manual instructions to remove or install module

• The module is limited to installation in mobile or fixed applications, according to

Part 2.1091(b)

• Separate approval is required for all other operating configurations, including

portable configurations with respect to Part 2.1093 and different antenna

configurations

• Authorized antennas per Part 15.204 (including ant. spec.)

• Antenna installation requirements, where relevant

• The finished product’s user manual must include following statements:

o Part 15.19 Warning Statement:

This device complies with part 15 of the FCC rules. Operation is subject

to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

o Part 15.21 Warning Statement:

The user manual for an intentional or unintentional radiator shall caution

the user that changes or modifications not expressly approved by the

party responsible for compliance could void the user’s authority to

operate the equipment.

o Note: The grantee is not responsible for any changes or modifications

not expressly approved by the third party responsible for compliance.

Such modifications could void the user’s authority to operate the

equipment.

o End-users must be provided with transmitter/antenna installation

requirements and operating conditions for satisfying RF exposure

compliance:

 A separate section should clearly state “FCC RF Exposure

requirements”

 Required operating conditions for end users