Datasheet

NXP Semiconductors
AN12395
OM-SE050ARD hardware overview
AN12395 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2019. All rights reserved.
Application note Rev. 1.1 — 27 June 2019
534311 10 / 24
Figure 7. OM-SE050ARD jumper J13 and J14 location
4.4 Reset pin routing
Jumper J12 allows you to control the I
2
C reset pin routing of the SE050. Table 5 indicates
the J12 configuration.
Note: The SE050 reset pin does not apply for the I
2
C interface.
Table 5. Jumpers for reset pin routing configuration
Jumper Description Open 1-2 2-3
J12 SE050_RST pin Not connected Routed to J11:3
strip pin connector
Routed to
Arduino R3
(Default)
Figure 8 highlights in blue the location of Jumper J12.