User guide

6.2 Downloading and debugging firmware with CodeWarrior 10 IDE
6.2.1 Connecting the JTAG debugger
After CodeWarrior version 10 is installed, connect the Freescale MCU JTAG debugger, USB TAP, or
P&E Micro Multilink to the MP board. The correct direction to plug-in the cable is shown in these figures.
Figure 7 Debugger connecting
Debugger board J5 pin #14 –>
A11 board J4 pin #1
USB TAP
Red line linked to Pin 1
WCT1012 15W Single Coil TX V3.0 Reference Design System User’s Guide, Rev. 0, 09/2015
8 Freescale Semiconductor