User guide

Installing and Using the Netcomm Device Drivers
Using the Netcomm Device Drivers
41 MPC8568E Kit Configuration Guide
Figure 4.8 CodeWarrior™ Debugger Window
9. Connect a Gethernet loopback cable (provided with the processor board) to the
processor board port labeled GETH1.
10. Connect a second Gethernet loopback cable (provided with the processor board) to the
processor board port labeled GETH2.
11. In the debugger window, click the run button.
The program resumes execution, transmits/receives 200 Ethernet frames, writes status
messages to the console window, and terminates.
Figure 4.9
shows the console window after program termination.