User guide

Installing and Using the Netcomm Device Drivers
Using the Netcomm Device Drivers
39 MPC8568E Kit Configuration Guide
NOTE At this point, you can use the project window’s build target dropdown menu to
select other use cases available for the Geth protocol.
You may want to try those use cases that match your needs. However, we
recommend that you do this after you complete this section.
5. Modify the build target’s settings, so it uses the USB TAP 8568 remote connection.
a. Press Alt-F7.
The Target Settings window (Figure 4.6
) appears.
Figure 4.6 Target Settings Window Showing Remote Debugging Settings Panel
b. From pane on the left side of the Target Settings window, select Remote
Debugging.
The Remote Debugging target settings panel appears on the right side of the
Target Settings window.
c. From the Connection dropdown menu of the Remote Debugging target settings
panel, select USB TAP 8568.
d. Click Apply.
The IDE assigns the USB TAP 8568 remote connection to the SimpleUseCase
build target.