User guide

Installing and Using the Netcomm Device Drivers

Installing the Netcomm Device Driver Package

MPC8568E Kit Configuration Guide

Each use case is based on at least one protocol. Each use case:

• Configures the device

• Configures the MDS board

• Generates and transmits data on a peripheral (for example, a UCC or an MCC)

• Receives data from the peripheral

• Compares the transmitted and received data

• Presents the results of the use case

NOTE You must use CodeWarrior for Power Architecture Processors, v8.7 with the

Netcomm Device Drivers, v2.0 package.

Using CodeWarrior for Power Architecture v8.8 with the Netcomm Device

Drivers, v2.0 package is not supported.

NOTE The QUICC Engine™ utility (QEU) includes most of the same use cases as the

Netcomm Device Drivers package. Using the QEU, you can view all

parameters that can be configured in a device, microcode, and driver using a

specific protocol. The QEU is included in the device drivers package.

The sections of this chapter are:

• “Installing the Netcomm Device Driver Package”

• “Using the Netcomm Device Drivers” on page 34

Installing the Netcomm Device Driver

Package

The Netcomm Device Drivers package includes:

• The QUICC Engine utility

• The Netcomm device drivers

When you install this package, both these components are installed, so this installation

procedure applies to the QUICC Engine Utility as well as to the Netcomm device drivers.