Datasheet

Hardware setup
PMSM Field-Oriented Control on MIMXRT1050 EVK, User's Guide, Rev. 0, 05/2018
NXP Semiconductors 3
Figure 1. MIMXRT1050-EVK board with highlighted jumper settings
The PWM modules are used in the motor-control application. For this purpose, it is necessary to solder
the resistors R278, R279, R280, and R281 to the board. These resistors are located on the underside of
the EVK board. For more details, see the schematic (revision A5).
Figure 2. Resistors needed for the PWM on the underside of the EVK board