Datasheet

Building and debugging the application
PMSM Field-Oriented Control on MIMXRT1050 EVK, User's Guide, Rev. 0, 05/2018
28 NXP Semiconductors
Figure 21. RT1050-EVK appears
5. Power down the board. Configure the board to the Hyper Flash boot mode – SW7-2 and SW7-3
pull up, the others pull down (Figure 21).
Figure 22. Hyper Flash boot mode configuration
6. Power up the board. The embedded application executes automatically. Now you can connect to
the running target.
For more information about booting from the Hyper Flash, see How to Enable Boot from Hyper Flash
and SD Card (document AN12107), section “OpenSDA Drag/Drop and boot from Hyper Flash”.
6.5. Replacing the firmware of the OpenSDA
To replace the firmware of the OpenSDA to support downloading to the Hyper Flash, follow these
instructions:
1. Download the latest firmware application from www.nxp.com/opensda (choose DAPLink vxxxx
- Supports on board hyper-flash).
2. Power down the board. Jumper J27 should be set to position 1-2 for the bootloader mode.