Datasheet
NXP Semiconductors 57
10XS3435
11 Revision history
Revision Date Description of changes
4.0 9/2008 • Initial release
5.0 10/2008
• Revised wording of VPWR Supply Voltage Range in Maximum Rating Table on page 5.
• Changed parameters for VPWR and VDD Power on Reset Threshold in Static Electrical Characteristics
Table on page 7.
• Changed Maximum rating for Output Source-to-Drain ON Resistance in Static Electrical Characteristics
Table on page 8.
• Changed Typical rating for HS[0,1] Current Sense Ratio (6.0 V < HS[0:3] < 20 V, CSNS < 5.0 V) in Static
Electrical Characteristics Table on page 9.
• Further defined Output Overtemperature Shutdown parameter in Static Electrical Characteristics Table
on page 10.
• Changed Typical parameter for HS[2,3] Current Sense Ratio (6.0V < HS[0:3] < 20 V, CSNS < 5.0 V) in
Static Electrical Characteristics Table on page 11.
• Changed parameters for Wake Input Clamp Voltage in Static Electrical Characteristics Table on
page 12.
• Added explanation for recovering to Normal Mode on page 28.
• Added HS[2:3] Driver Output Matching Time (t
DLY(ON)
- t
DLY(OFF)
)
6.0 12/2008 • Changed Orderable Part Number from PC10XS3435BPNA to MC10XS3435BPNA on Page 1.
7.0 7/2009 • Added MC10XS3435DPNA part number. The “D” version has different soldering limits.
8.0 10/2009
• Corrected minor formatting
• Separated definitions for the 10XS3435B and 10XS3435D in the Static and Dynamic Tables
9.0 05/2012
• Changed orderable part number MC10XS3435BPNA to MC10XS3435BHFK and MC10XS3435DPNA
to MC10XS3435SDHFK.
• Updated the pin soldering temperature limit from 10 seconds to 40 seconds (Note
(2)
and
(9)
).
• Updated Freescale form and style
10.0 8/2012 • Added “The UV fault is reported in the SPI status registers.” to Start-up sequence
11.0 5/2014
• No technical changes. Revised back page. Updated document properties. Added SMARTMOS
sentence to last paragraph on page one.
12.0 8/2018
• Updated as per CIN 201808007I
• Corrected T
OLLED
values in Table 6, Dynamic electrical characteristics
• Updated Openload detection in ON state for LED (added clarification for the usage of openload LED
function and changed D[6:0]=7F to D[7:0]=FF)