Datasheet

46 NXP Semiconductors
10XS3435
7.4.4.9 Previous Address SOA4 : SOA0 = 10111 (DIAGR2)
The returned data is the product ID. Bits OD2:OD0 are set to 011 for protected dual 10 mOhm and 35 mOhm high-side switches.
7.4.5 Default device configuration
The default device configuration is explained below:
• HS output is commanded by corresponding IN input or ON bit through SPI. The medium slew-rate is used,
• HS output is fully protected by the Xenon overcurrent profile by default, the severe short-circuit protection, the undervoltage and the
overtemperature protection. The autoretry feature is enabled,
• Openload in ON and OFF state and HS shorted to VPWR detections are available,
• No current recopy and no analog temperature feedback active,
• Overvoltage protection is enabled,
• SO reporting fault status from HS0,
• VDD failure detection is disabled.