Datasheet
NXP Semiconductors
UM11193
KITFS85AEEVM evaluation board
UM11193 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2020. All rights reserved.
User manual Rev. 2.1 — 30 January 2019
2 / 52
1 Introduction
This document is the user guide for the KITFS85AEEVM evaluation board.
This document is intended for the engineers involved in the evaluation, design,
implementation, and validation of FS8500 Fail-safe system basis chip with multiple
SMPS and LDO.
The scope of this document is to provide the user with information to evaluate the
FS8500 Fail-safe system basis chip with multiple SMPS and LDO. This document covers
connecting the hardware, installing the software and tools, configuring the environment
and using the kit.
The KITFS85AEEVM enables development on FS84/FS85 family of devices. The kit can
be connected to the FlexGUI software which allows you to play with registers, try OTP
configurations, and burn the part.
This kit is suitable for truck application running at 24 V nominal. It is able to sustain up to
60 V at V
BAT
.
It is delivered with empty OTP content in order to leave the opportunity to the user to
burn the OTP configuration. Burning the OTP three times, gives a good flexibility. The
board contains a superset device (MC33FS8530AE0S), allowing tests on all the FS84/
FS85 derivatives.
2 Finding kit resources and information on the NXP web site
NXP Semiconductors provides online resources for this evaluation board and its
supported device(s) on http://www.nxp.com.
The information page for KITFS85AEEVM evaluation board is at http://www.nxp.com/
KITFS85AEEVM. The information page provides overview information, documentation,
software and tools, parametrics, ordering information and a Getting Started tab. The
Getting Started tab provides quick-reference information applicable to using the
KITFS85AEEVM evaluation board, including the downloadable assets referenced in this
document.
2.1 Collaborate in the NXP community
The NXP community is for sharing ideas and tips, ask and answer technical questions,
and receive input on just about any embedded design topic.
The NXP community is at http://community.nxp.com.
3 Getting ready
Working with the KITFS85AEEVM requires the kit contents, additional hardware and a
Windows PC workstation with installed software.
3.1 Kit contents
• Assembled and tested evaluation board in an anti-static bag
• 3.0 ft USB-STD A to USB-B-mini cable
• Two connectors, terminal block plug, 2 pos., str. 3.81 mm
• Three connectors, terminal block plug, 3 pos., str. 3.81 mm