Datasheet

Product data sheet Rev. 3.0 — 19 September 2016 15 of 27

NXP Semiconductors

JN5169-001-M0x-2

ZigBee 3.0, ZigBee PRO and IEEE802.15.4 modules

This device has been designed to operate with the antennas listed above, and having a

maximum gain of 2 dBi. Alternative vertical antennas may be used provided that the gain

does not exceed 2 dBi. Antennas having a gain greater than 2 dBi are strictly prohibited

for use with this device.

The required antenna impedance is 50 .

13.1.2 High-power module usage limitation

The high-power module variants are classified as ‘mobile’ device pursuant with FCC §

2.1091 and must not be used at a distance of < 20 cm (8”) from any people. This applies

to the JN5169-001-M06-2 module type (XXMJN5169M6V2).

Remark: In the event that these conditions cannot be met (for certain configurations or

co-location with another transmitter), then the FCC authorization is no longer considered

valid and the FCC ID cannot be used on the final product. In these circumstances, the

OEM integrator will be responsible for re-evaluating the end product (including the

transmitter) and obtaining a separate FCC authorization.

The OEM integrator has to be aware not to provide information to the end user regarding

how to install or remove this RF module in the user manual of the end product.

The user manual for the end product must include the following information in a prominent

location;

“To comply with FCC’s RF radiation exposure requirements, the antenna(s) used for this

transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.”

13.1.3 FCC end product labeling

The final ‘end product’ should be labeled in a visible area with the following:

“Contains TX FCC ID: XXMJN5169M0V2, XXMJN5169M3V2 or XXMJN5169M6V2” to

reflect the version of the module being used inside the product.

13.2 European R&TTE Directive 1999/5/EC statement

JN5169-001-M00-2 and JN5169-001-M03-2 are compliant with ETSI EN 300 328 V1.9,

EMC, EN 301 489-17 v2.1.1 (2009-02) and the Basic Safety Assessment (BSA) EN

60950-1:2006 (2006-06) and are subject to a Notified Body Opinion.

These modules are approved for use with the antennas listed in the following table. The

JN5169-001-M06-2 module is not approved for use in Europe.

Alternative vertical antennas may be used provided that the gain does not exceed 2 dBi.

Table 13. Antennas description (R&TTE)

Brand Model Number Description Gain (dBi) Connector type

1 Aveslink Technology, Inc E-0005-AC vertical- flying lead 2 RP-SMA

2 Aveslink Technology, Inc E-2411-GC vertical - swivel 2 RP-SMA

3 Aveslink Technology, Inc E-2410-CA vertical - bulkhead- flying lead 2 FL

4 Aveslink Technology, Inc E-2410-HA vertical- flying lead 2 FL

5 Aveslink Technology, Inc E-2410-GC vertical - swivel 2 RP-SMA